PCUT Users Manual. Contents Welcome. Install SignBlazer Software. The PCut is an exciting advancement in the world of vinyl cutting. It allows the user to perform advanced cutting functions that were previously unavailable to entry level machines. Setup instructions, cutter instructions, sign software, windows software, signtools homepage, home, sign cutting, sign making. Creation PCut CTN 1080E.
Hi,
I realize that the application is not running in Windows 10. We will help you.
I suggest you to install the Application in Compatibility mode and check if it helps.
This issue might have caused due to incompatibility issue. Install the application in compatibility mode. Compatibility mode runs the program using settings from a previous version of Windows.
Follow these steps to install the drivers in compatibility mode and check if that helps.
- Find the application installer file location.
- Right-click on the setup.exe file and click on ‘properties’.
- Click on the ‘compatibility’ tab and check the box ‘Run this program in compatibility mode for’ and select operating system from the drop down menu and proceed with the installation.
- Once this is done, restart the computer and check if the issue persists.
Refer: Using Compatibility Mode to Resolve Driver problems - suggested by Andre Da Costa.
Hope this helps. If any other issues get back to us. We are glad to help you.
14 people were helped by this reply
·Did this solve your problem?
Sorry this didn't help.
Great! Thanks for marking this as the answer.
How satisfied are you with this reply?
Thanks for your feedback, it helps us improve the site.
How satisfied are you with this response?
Thanks for your feedback.
Because I searched for DAYS, I will add my comment. I had the same problem with my PCut CT1200 vinyl cutter, running through a COM port in Windows 7 fine, then disappeared when I upgraded to Windows 10.
I uninstalled the LXi VinylExpress software, and re-installed. I didn't use the driver on the CD with my old software, but had downloaded another copy so it was on my computer. I installed the downloaded driver in compatibility mode back to Windows 7, just as Sachin instructed, but wanted to add that my cutter didn't show up still, until I unplugged and re-plugged the USB from the cutter while it was on. As soon as I plugged the USB cable back in, the new COM port showed up in Device Manager, and finally I could run a test cut.
Thank you.
4 people were helped by this reply
·
Did this solve your problem?
Sorry this didn't help.
Great! Thanks for marking this as the answer.
How satisfied are you with this reply?
Thanks for your feedback, it helps us improve the site.
How satisfied are you with this response?
Thanks for your feedback.